01Our crew erects the panels, seals every joint, fits the insulated door, mounts the evaporator and condensing unit, brazes the copper piping and wires the control panel. Because one team does everything, there is no finger-pointing between panel, refrigeration and electrical contractors.
Before handover the system is pressure tested with nitrogen, evacuated to remove moisture and charged with the correct refrigerant. We then run a pull-down test and train your staff on daily operation.
02Older rooms often lose efficiency through damaged panels, failing door seals and ice forming where warm air leaks in. We find where the heat is getting in, replace or re-seal panels, repair doors and heater frames, and fix the refrigeration faults that usually come with these problems.
We repair rooms installed by any contractor. For urgent freezer or chiller breakdowns, our 24/7 line connects you directly to a technician.
03High humidity and heat put extra stress on cold rooms here. We use heater wire on freezer door frames, seal joints carefully to keep moisture out of the insulation, plan floor insulation for freezers and protect outdoor units from rain and afternoon sun wherever possible.
